Can I Hang Cabinets On Plaster Walls

The wall is about 2 inches thick the living room is on the other side.

Can i hang cabinets on plaster walls.

You may not notice the damage but as plaster comes loose from the lath it will eventually begin to sag and soon fall off the wall if the. Put away the hammer. In this diy video i ll show how to hang stuff on plaster and lath walls using a molly bolt. Hanging a cabinet in bathroom is probably even easier that in the kitchen because very often you will have solid brick walls.

You can hang almost any cabinet on cinder block walls using concrete inserts. We want to put 3 24 inch wode cabinets followed by a 36 inch bridge and 18 inch wide pantry. This is actually easier than hanging on stud walls because you don t need to locate and hit studs. 2 of the 3 walls are outside walls of the house so the studs were 16 inches on center and there were no problems.

They do have stud finders that can penetrate the plaster walls and reliably find the studs don t expect them to be 16 on center. I am re modelling my kitchen. You can also hunt for the studs with a screw where the cabinets will be hung then put the cabinets up and the extra holes will be hidden behind the cabinets. Once the studs are located the process of hanging the cabinets is much like that used in hanging a cabinet on any other wall surface and should proceed smoothly.

However the 3rd wall is plaster on mesh with no studs. Put any cool top over them and you have a kitchen island. The plaster wall itself is not strong enough to support the weight of the cabinet but installation into the wall studs should be sufficient for supporting the weight of the kitchen cabinets. I can still give you some great ideas for hanging on plaster walls.

Hanging heavy frames on the wall can be tricky and with all the. If the plaster is about 3 4 thick and over metal lath it is actually quite strong. If the heads of toggles then you can t argue with success. How to hang a bathroom cabinet on plasterboard wall.

Or build a stilt base for the cabinets using 2x4 s or similar and set the cabinets up on those the weight of the cabinets will be absorbed on the stilts instead of the wall stud anchors but can be reinforced minimally to the wall via the cabinet backs and the 2x4s. Remember the pull is downward more than outward so the toggles have to hold tightly enough to hold the cabinet to the wall and the bolt has to hold the weight from falling down the wall. Hammering nails into plaster is a quick way to knock plaster loose from the lath that is supporting it. It will probably.